How to prevent the small excavator from turning over?

Disastrous small excavator rollover problem

Reason 1: Handrail frame when going downhill

Everyone knows the surpassing off-road capability of small excavators. Through the cooperation of the track and the working device, the excavator can climb up a steep slope or go down easily. It is easy for everyone to ignore dangerous situations. When a small excavator is going downhill or driving along a trailer, many drivers will push the front windshield or door frame with their left hand and operate the excavator with their right hand. walk. At this time, if the door is opened and not locked, the door will close quickly due to gravity, which is usually a great force. Hold your hand on the door frame and it will be pinched. Very serious consequences.

Therefore, when the small excavator is working, there is a lock on the door of the cab of the small excavator, and there is a lock when it is opened, and it must be locked regardless of whether the door is open or closed. The driver should try not to grab the door frame.

Secondly, hold the boom when walking

Many novices or apprentices think that the boom of a small excavator is raised to the highest, the stick is fully opened, and the bucket is facing the sky, so the sight line will be better when walking, and it will be cool if you walk. Walking in this way is very dangerous. Because the working device is taller and the center of gravity is higher, if it is slightly uneven, the ground will fall over.

Therefore, be sure not to calm down when walking and doing homework. The most important thing is to be optimistic about the path under your feet.

Third, driving on soft ground

When small excavators work on soft ground such as swamps and river beaches, first use a bucket to test whether the ground can withstand the weight of the excavator. If you forget this process, unless you are driving an amphibious excavator, it may have serious consequences. Although the excavator is specially designed for crawlers and has a large contact area with the ground, accidents caused by the excavator in the mud may also occur from time to time! Note that this can be avoided. In order to avoid being trapped when working on soft land such as swamps or river beaches, you should pay attention to the following points:

1. Try it with a bucket first.

2. Don't stay in the same place for a long time.

3. Take straighter and turn less.

If the small excavator gets stuck in the mud, don't worry. Don't try to climb out with a set of climbing methods, it will only get deeper and deeper. There are many ways to save:

1. If the trap is not very deep, hollow out the two tracks first, and then try again.

2. If you still can't come out, try the depth of the mud first. If it is not very deep, just dig the dirt in front of you to make a way for yourself.

Slowly approach the hard ground on the shore.

3. If the mud is infinitely deep, it is to rent a few iron plates or road base plates, and press it under the track, you can easily get out of the predicament.

4. Blind sight